|JOINTING||bookmatched • random-matched
(depends on the references)
satin • relief • matte • brushed
|SUBSTRATES||particle board (standard, water-repellent or fire-retardent)
MDF (standard or fire-retardent)
M0 substrate • honeycomb... please consult us
|SUBSTRATE THICKNESS||particle board :
10 mm (0.39”) • 12 mm (0.47”) • 16 mm (0.62”) • 19 mm
(0.74”) • 22 mm (0.86”)
16 mm (0.47”) • 19 mm (0.62”) •
others: please contact us
Ceilings : 60 x 60 cm • 120 x 60 cm
2 visible sides • same wood specie
1 visible side • 1 counterbalancing side
round • slote • others: please consult us
|EDGE FINISH||veneered (with the Oberflex edge banding) •
unfinished• softformed • others, please consult us
|EDGE TREATMENT||rough-cut • precision-milled • custom-treated: grooved,
rebated, angle machining ...
others, please consult us
|FIRE RATINGS||M2 (n° 9153-00 of SNPE) / standard particle board
M1 (n° 11639-04 of SME) / fire-resistant particle board
M1 (n° 9152-00 of SNPE) / fire-resistant MDF
The panels should be fabricated in compliance with Specification NF XP B 54-202 : «Panneaux décoratifs plaqués-bois – Spécifications (Decorative, wood-veneered panels - Specification) or equivalent.
Fabrication should normally take place in the following conditions:
The rooms where the panels are to be installed should normally conform to the following conditions:
If the panels are installed in a dry area: The relative air humidity during the stablilization phase should be within the range of 40 to 60%. Once the panels are installed, the ambient air humidity may exceed 65% only for a couple of weeks per annum.
If the panels are installed in a humid area (bonded to a hydrophobic substrate):
The relative air humidity during the stabilization phase may exceed the range of 40 to 60%.
Once the panels are installed, the ambient air humidity may exceed 85% only for a couple of weeks per annum.