Brut d'Ober

More than 30 genuine wood species laminated on a kraft backer

References

Mahogany
Mahogany
African Mahogany
African Mahogany
Ako
Ako
Anigre
Anigre
Alder
Alder
Bamboo
Bamboo
Canadian Birch
Canadian Birch
Bubinga
Bubinga
Chestnut
Chestnut
Light Oak
Light Oak
Canadian Maple
Canadian Maple
Birdseye Maple
Birdseye Maple
Light Ash
Light Ash
Steamed Beech
Steamed Beech
Figured Mahogany
Figured Mahogany
American Cherry
American Cherry
Figured Movingui
Figured Movingui
American Walnut
American Walnut
American Elm
American Elm
Pine
Pine
Wild Pear
Wild Pear
Sapelli
Sapelli
Sucupira
Sucupira
Sycamore
Sycamore
Teak
Teak
Wenge
Wenge
Reconstitued Wenge
Reconstitued Wenge
Natural Zebrano
Natural Zebrano

The product


Characteristics

JOINTING bookmatched or random-matched
(depends on the references)
FINISHES veneer pre-sanded on its surface
DIMENSIONS standard :
305 x 127 cm (4’ x 10’) • 252 x 127 cm (4’ x 8’)
doors :
215 x 95 cm • 215 x 127 cm
305 x 95 cm • 252 x 95 cm
• 305 x 127 cm
THICKNESS 0,8 mm (0.03’’)
BENDING cold bending up to a 10 cm radius parallel to the wood grain or 12 cm radius perpendicular to the wood grain

Download technical details

Technical datasheet

The panels are fabricated and glued in the same manner and on the same substrates as conventional laminates. In addition, we would like to add the following comments:

Handling

Handle carefully, the wood veneer may split, if handled incorrectly.

Substrates

When using 0.8 mm thick panels, it is imperative to bond a perfectly flat substrate.

Hot press bonding:Do not exceed 70°C.

Balancing

We strongly advise against using conventional type laminates for this purpose, the two materials being subject to differing expansion coefficients . For instance, doors may be backed both sides with Brut d’Ober sheets of same thickness and same surface finish. This is the same case when using thin substrates and/or in big dimensions.

Wall panelling, on the contrary, allows backing with Brut d’Ober one side only, provided the sheets is rigidly held in place by a securing system or reinforcement, while the back side is protected from humidity and covered with a vapour-resistant coat of paint, lacquer or varnish.

Cleaning off glue deposits

Proceed as for a solid wood surface.

Surface finish

Panels supplied pre-sanded, needing slight additional sanding by the fabricator for a professional result.

Technical assistance

Our technical department is at your disposal to help and advise in each particular case. The information offered in such cases, as well as that contained herein, is given to the user in good faith and to the best of our knowledge. However, the only criteria we take into account and guarantee is the intrinsic quality of our products.